See the Jack Rabbit Tool in Action
Pre-drill your hole, countersink and drive your wood screws quickly and accurately with the Jack Rabbit Tool. One twist of the wrist changes your drill to a driver. Another twist, and you have your drill back, ready to move to the next screw. See the Jack Rabbit tool in action below.
Three Quick Steps to Inserting Pre-drilled, Countersunk Screw
DRILL
Jack Rabbit is the quickest way to drill-countersink and drive for wood screws. It fits any drill, corded or cordless. Shown is the Deluxe Set in use. From the right you can see the Mag Ring (brass piece next to the chuck), the Jack Rabbit with pilot bit and countersink, and the depth stop for an accurate wood-plug finish.
PULL
After drilling a pilot hole and countersink, its time to drive the screw. The Jack Rabbit patented release mechanism is as simple as it gets. You just pull on the wide part to release it from the driver bit 1/4 shank. One easy pull, it unlocks and slides off. There's nothing else to do.
DRIVE
Now you're ready to drive the screw. Its easy to find a cheaply made bit, we offer only the best with a #2 Phillips on one end and a #2 Square on the other, 2-1/2" length.
The Mag Ring has more than double the power of a standard magnetic bit holder. It even holds screws when you are removing them. Drive the screw, slip the Jack Rabbit back on and you're ready for the next hole. Its as simple as that.
CASE
Each item snaps in place and stays that way. It is designed to fit in
a pocket or a work belt without wasting your valuable space. A sturdy
slide lock keeps it closed.
7 1/2" x 2 1/4" x 1 1/8"
Sets and Parts
The diagram above shows all the components available for the Jack Rabbit Tool. See the Products page for sets. Any part can be purchased individually from the Parts page.
If you have any questions about Jack Rabbit operation or the components
that make this great time-saving tool. please don't hesitate to contact
us.
What the pos say ...
With Jack Rabbit we find 50% time savings on wood
screw intensive construction.
Design Fabricators, Colorado,
manufacturer of 90% of new Starbuck Coffee Shop interiors worldwide.
I would recommend this product to anyone who works
on cabinets or doors. You can predrill and countersink in one motion with
one drill, and drive screws quickly. I installed 12 oak cabinet doors
in half the time and effort it took before, with fewer tools.
Handyman Magazine Product Tester's Reports
Billy Scott Red Bay, AL
Jack Rabbit makes the combo drill-counter-sink-driver
we use around here every day. It's a real tool, not an afterthought.
New Yankee Workshop Web site
Home | Products | Parts | Demo | Q & A |Testimonials | About Us | Contact
